When the high temperature in summer comes, many laser cutting machines will generate a lot of heat when working, which will cause some failures. Therefore, when using a laser cutting machine in summer, pay attention to preparing for the cooling of the equipment. In the case of high temperature, people will suffer from heatstroke, and machinery is no exception. To prevent heatstroke and maintain the laser cutting machine can prolong the service life of the equipment.

      Water cooling equipment

      The water cooler is the necessary cooling equipment for the laser cutting machine. In the high temperature environment, the deterioration of the coolant is very fast. It is recommended to use distilled water and pure water as the coolant. In the process of use, it is necessary to regularly clean the scale attached to the laser and the pipeline, so as to avoid the accumulation of scale and the blockage of the coolant, which will affect the cooling and cooling of the laser. The water temperature of the cooling liquid should not be too different from the room temperature, so as to avoid condensation caused by the excessive temperature difference. As the temperature gradually increases in summer, the working pressure of the cooling system of the laser cutting machine increases sharply. It is recommended to check and maintain the internal pressure of the cooling machine before the high temperature. , timely adjustment to adapt to high temperature weather.

     Lubrication

       Each transmission part needs to be wiped and dusted frequently to keep the equipment clean and tidy and make the equipment run more smoothly. Lubricating oil needs to be filled between the guide rails and the gears, and the filling time interval should be adjusted. And often observe the oil quality. For machinery working in high temperature areas, the viscosity level of the oil should be appropriately increased. The temperature of the grease oil is easy to change, so it should be properly refueled to ensure lubrication without debris. Carefully check the straightness of the cutting table and the track of the laser cutting machine and the verticality of the machine, and maintain and debug it in time if it is found to be abnormal.

      line check

       Check and replace worn wires, plugs, hoses and connectors. Check whether the connector pins of electrical components are loose, and tighten them in time to avoid electrical burnout and unstable signal transmission caused by poor contact.

       The equipment has a certain loss during use, especially when the high temperature summer comes, protect the laser cutting machine and keep it in good condition all the time, in order to bring greater benefits to yourself.